Advertisement
Available languages
Available languages
Ceiling mount:
Type 2 : Wires from Conduit
Step 1: Drill two holes and install the
Step 2: I nsert the wire conduit into the
mounting base.
mounting base.
Step 3: Connect the circuit wires to the fixture
Step 4: Tighten the screws, insert end caps,
wires using wire nuts and electrical tape for a
and adjust fixture mounting base.
more secure connection.
Wall mount:
Type 1: Wires from bottom hole
Step 1: Remove the pipe cap from bottom.
Step 2: Thread the wire through the central
hole in the base
When installed on the outdoor side wall,
the inside bend pipe of this part can prevent
water flow in from the wall seam
Step 4: Connect the circuit wires to the fixture
Step 5: Tighten the screws and insert end
wires using wire nuts and electrical tape for
caps, adjust the bulb to the angle you want,
a more secure connection.
then lock.
Waterproof
plaster
Step 3: Screw into the base.
Keep 45° angle
between screw
and pipe holes
3
ESF-WH-071
Wall mount:
Type 2: Wires from Pipe
Step 1: Tighten the bottom hole mounting
Step 2: I nsert the wire conduit into the
and aim it with the upper hole.
mounting base.
Keep 45°angle
between screw
and pipe holes
Step 4: Tighten the screws and insert end
Step 3: Connect the circuit wires to the fixture
caps, adjust the bulb to the angle you want,
wires using wire nuts and electrical tape for a
then lock.
more secure connection.
Made in China
Waterproof
plaster
4
ESF-WH-071
Advertisement
