Cypress Envirosystems WPT-810-RPT Installation Manual

1. Overview
The Cypress Envirosystems Wireless Pneumatic Thermostat (WPT) retrofits an existing
pneumatic thermostat to provide Direct Digital Control (DDC) like zone control
functionality at a fraction of the time and cost without disturbing occupants.
The WPT enables remote monitoring of zone temperature, branch pressure, remote
control of setpoints, and programmable setback or setup of the pneumatic HVAC
systems. It also enables integration with utility Demand Response programs.
The Wireless Pneumatic Thermostat repeater (RPT) is one of the components of WPT
wireless network. The RPT is used to extend the wireless range of the WPT network by
allowing more WPTs to be connected in each wireless network. When the WPT USB
Hub (HUSB) is located out of RF range of the WPT, multiple RPTs can be used to extend
the range. For more details, refer to WPT Wireless Network Planning Guide.
1.1. Components
The WPT-810-RPT kit includes the following components:
Wireless repeater
•
Universal wall bracket
•
Mounting screws, #6 x 1" self-tapping (x2)
•
1.2. Prerequisites for Installation
The WPT system relies on a wireless network for communication. The following tasks
must be completed before proceeding to RPT installation:
Wireless survey performed using the WPT-800-RKIT
•
Installation of the WPT Green Box
•
Installation of the HUSB
•
Assignment of network IDs and RPT IDs
•
Assignment of RPT locations
•
Run low voltage power to the RPT location
•
Manuals for the WPT, WPT Green Box, HUSB and other manuals related to the WPT
system can be found at http://www.cypressenvirosystems.com.
1.3. Tools Required for Installation
Phillips-head screw driver
•
1/16" hex Allen wrench
•
RPT Installation Manual
Doc No. 910-00027-01 Rev 01
Page 1 of 12