Safety Decals - SYSTEMS Poweramp PowerHold Owner & User Manual

PRECAUTIONS

Safety Decals

1.50"
Arc Flash and
Shock Hazard
PPE [Personal Protection
Equipment] Required
De-energize equipment before
working on or inside. Do not
open cover without appropriate
PPE. Refer to NFPA 70E for
PPE requirements. This panel
may contain more than one
power source.
Hazardous Voltage
Will Result in Death
or Serious Injury
1.50"
File Name: 1751-0736 Rev A
Decal Size: 1.5 x 3
Lockout/Tagout
power before
servicing.
Comply with
OSHA 1910.147
1751-0857 Rev A
Control Box Size: Overlay
Decal Size: 1.5 x 3
File Name: 1751-0857 Rev A
Note: This is a example of dock leveler safety decals. See specific model manual for correct safety decal
sheet, or consult Systems, LLC Tech Services.
4
DO NOT
1
FORK THIS SIDE
DO NOT
FORK THIS SIDE
1
1751-0329
FORK
3 HERE
1751-0330 Rev C
FORK
File Name: 1751-0330 REV C
3
HERE
Decal Size: 5.375 x 1.75
1751-0330 Rev C
1751-0330
Two positions one on top of each fork pocket.
File Name: 1751-0330 REV C
Decal Size: 5.375 x 1.75
CRUSH HAZARD
DO NOT ENTER PIT unless dock leveler is
securely supported by maintenance prop. Place
5
barriers on driveway and dock floor to indicate
service work being performed. Failure to comply
will result in death or serious injury. Refer to
owner's/user's manual for proper maintenance
procedures.
1751-0726 Rev B
1751-0726
File Name: 1751-0726 Rev B
Decal Size: 5.92 x 2.36
CRUSH HAZARD
Maintenance prop must
support leveler behind bar.
6
Do not force maintenance
prop forward of bar to
support lip. Refer to
owner's/user's manual for
proper use. Failure to
comply will result in
death or serious injury.
1751-0727 Rev B
1751-0727
File Name: 1751-0727 Rev B
CRUSH HAZARD
Decal Size: 5.06 x 2.40
7
Do not work under dock leveler unless this maintenance prop has been secured in the
upright position. Failure to comply will result in death or serious injury. See owner's/user's
manual for proper procedures
1751-0729
10
File Name: 1751-0729 Rev A
CRUSH HAZARD
Decal Size: 8.72 x 1.02
DO NOT REMOVE hydraulic cylinder until leveler is
Material: Ritrama 3-1190 (3.5 mil thick) calendered vinyl
02 hi-tack permanent acrylic adhesive
safely supported by maintenance prop. Refer to
Ritrama 3-7146 (1.0 mil thick) clear polyester laminate
owner's/user's manual for proper maintenance
procedure. Failure to comply will result in death or
serious injury.
1751-0138 Rev B
1751-0138
5.05"
File Name: 1751-0138 Rev B
Decal Size: 4 x 2
CRUSH HAZARD
Open the pin latch and insert
through the maintenance
11
prop housing and prop
completely. Close the pin latch
to secure prop. Use every
time dock leveler is serviced.
Failure to comply will result
in death or serious injury.
1751-0731 Rev A
1751-0731
File Name: 1751-0731 Rev A
Decal Size: 5.05 x 2.40
4
Right Platform Side
1
1751-0329 Rev A
File Name: 1751-0329 Rev A
Decal Size: 13 x 2
1751-0329 Rev A
File Name: 1751-0329 Rev A
Decal Size: 13 x 2
Unsupported dock leveler
ramps can lower unexpectedly.
Before allowing vehicle to leave
4 the dock always:
•
•
Failure to follow posted instructions will result in death or serious injury.
Unsupported dock leveler
ramps can lower unexpectedly.
Before allowing vehicle to leave
the dock always:
4
•
•
Failure to follow posted instructions will result in death or serious injury.
1751-0730
8
8
1751-0729 Rev A
HP SERIES
9
1751-0640
6
Right Platform Side
8
10
5
9
Figure 2
2.43"
PROUDLY
MADE
USA
IN
2
SYSTEMS, INC.
GERMANTOWN, WI
MALVERN, AR
1751-0735
Control Box Size:
Decal Size: 2.75 x 1.25
File Name: 1751-0735
OPERATION
7. Stay clear of hinges and front and
1. Read and follow all instructions and sides of moving dock leveler.
warnings in owner's/user's manual. 8. N e v e r u s e d a m a g e d
2. Use of dock leveler restricted to
malfunctioning dock leveler. Report
trained operators problems immediately to supervisor.
3. Always chock trailer wheels or
engage truck restraint before
MAINTENANCE/SERVICE
operating dock leveler or beginning to 1. Read and follow all instructions,
load or unload.
w a r n i n g s a n d m a i n t e n a n c e
4. Never use hands or equipment to
schedules in the owner's/user's
move ramp or lip manual.
5. Before activating dock leveler:
2. Maintenance/Service of dock leveler
Ensure no equipment, • Ensure trailer is backed in against
restricted to trained personnel.
bumpers.
3. Place barriers on the driveway and
material or people are on
• Remove any end loads if required.
dock floor to indicate service work is
dock leveler.
• Check trailer alignment to avoid lip being performed.
interference. If lip does not lower to 4. DO NOT ENTER PIT unless dock
trailer bed, reposition vehicle. leveler is securely supported by
Return dock leveler to its
6. Ensure truck bed supports extended maintenance prop.
stored position at dock level. lip or leveler frame supports the ramp 5. If electrically powered turn off and use
before driving on ramp.
OSHA lockout/tagout procedures.
Call 262.255.1510 for replacement placards, warning labels, or owner's/user's manuals.
1751-0730 Rev B
OPERATION 7. Stay clear of hinges and front and
1. Read and follow all instructions and
sides of moving dock leveler.
warnings in owner's/user's manual. 8. N e v e r u s e d a m a g e d
2. Use of dock leveler restricted to malfunctioning dock leveler. Report
File Name: 1751-0730 Rev B
trained operators
problems immediately to supervisor.
Decal Size: 9.12 x 3.25
3. Always chock trailer wheels or
engage truck restraint before
MAINTENANCE/SERVICE
operating dock leveler or beginning to
1. Read and follow all instructions,
load or unload. w a r n i n g s a n d m a i n t e n a n c e
4. Never use hands or equipment to
schedules in the owner's/user's
move ramp or lip
manual.
5. Before activating dock leveler: 2. Maintenance/Service of dock leveler
Ensure no equipment, • Ensure trailer is backed in against
restricted to trained personnel.
bumpers.
material or people are on 3. Place barriers on the driveway and
• Remove any end loads if required. dock floor to indicate service work is
dock leveler. •
Check trailer alignment to avoid lip being performed.
interference. If lip does not lower to 4. DO NOT ENTER PIT unless dock
trailer bed, reposition vehicle. leveler is securely supported by
Return dock leveler to its
6. Ensure truck bed supports extended maintenance prop.
lip or leveler frame supports the ramp 5. If electrically powered turn off and use
stored position at dock level.
before driving on ramp. OSHA lockout/tagout procedures.
Call 262.255.1510 for replacement placards, warning labels, or owner's/user's manuals.
1751-0730 Rev B
File Name: 1751-0730 Rev B
Decal Size: 9.12 x 3.25
Decal Size: 6 x 2
File Name: 1751.0651
1751-0651
Decal Size: 6 x 2
File Name: 1751.0651
TM
Decal Size: 6 x 2.4
File Name: 1751.0640
4
9
Serial Tag
Left Platform Side
1
3
Decal Placement
7
11
for H Series
2
4111-0016 — Aug. 2019
© 2019 Systems, LLC
o r
o r