CoverCraft Form-Fit Use And Care Instructions

LIMITED LIFETIME WARRANTY
Form-Fit™ motorcycle covers are warranted for life to the original purchaser.
Warranty coverage protects against defects in material and workmanship as
well as the fabric becoming unserviceable during normal use. After factory
inspection, We will repair or replace the cover or specific panels judged to be
unusable. Warranty does not cover fading, which occurs naturally on any
products used outdoors. This fabric is breathable to allow moisture,
condensation and heat to escape from under the fabric.
To process your warranty claim, contact:
Customer Service at 800-426-8377 M-F, 9AM to 4PM CST
COVERCRAFT
100 Enterprise Blvd.
Pauls Valley, OK 73075
All returns must have an RA # (return authorization) noted on the box.
NOTE - Form-Fit covers are not designed for use when towing. Serious
damage can occur to the cover and the paint surface of the bike may
also be damaged. If you use a cover for towing you do so at your own
risk.
Printed in USA Form # 1320133 (6/08)
Use and Care Instructions
Your new Form-Fit® indoor cover is manufactured with a polyester knit fabric
that has spandex in the yarns to allow the cover to stretch and follow the
contours of the vehicle. The addition of spandex helps the fabric retain it's
original memory so the cover doesn't get "baggy" after extended use. The
material is breathable and soft against any fine paint finish. It's light weight,
easy to handle, and compact to take up minimal storage space. Best of all,
it can be easily cleaned in most home washing machines and dryers.
INSTALLATION
Installation of cover is easiest if you drape the cover over the windscreen or
handlebars and then place the cover over the front tire. Then pull the cover
towards the rear of the bike and place it around the rear tire. To remove the
cover, fold each side up and lay it on top of the bike. Then fold it in sections,
or roll it, from the rear forward to the front. Next time you install the cover you
will be able to place the bundle in the handlebar/ windscreen area and complete
the installation as noted above. Use care in installing the cover on a motorcycle
which has just been ridden, to be sure any hot exhaust pipes are given
adequate time to cool
The elastic at each end of the cover will keep it in place under all normal
conditions.
STORAGE BAG
Your new cover is supplied complete with a storage bag. After removing the
cover from the vehicle, place it inside the storage bag if the cover will not be
used for a period of time.