Wirquin CLUB SEAT Installation Instructions

CLUB SEAT
INSTALLATION INSTRUCTIONS

CARE AND CLEANING OF YOUR WIRQUIN TOILET SEAT:

f The seat and cover should be cleaned using warm soapy water.
f Do NOT use aggressive or abrasive cleaners as this may scratch the
surface.
f The hinges should be cleaned using soap or mild detergent.
f After cleaning, the hinges should be rinsed in clean water and
dried.
f NEVER use bleach, concentrated cleaners or acids as this will cause
discolouring and pitting.
f Do not leave bleach in the toilet bowl with the cover closed
because it may cause discolouration of the seat and hinges.
f The cover of the toilet seat is for decorative purposes only. The lid is
not guaranteed to carry weight. (Do NOT stand or sit on the lid.)

BEFORE INSTALLING YOUR WIRQUIN TOILET SEAT:

f Verify the colour and size.
f Check that the visual surface is free from cracks and surface defects.
f Ensure that all components are present and in a satisfactory
condition.
f No claims will be entertained after installation.
A

OPTION 1 - PLASTIC HINGES

OR
B
OR

OPTION 2 - QUICK BOTTOM FIT STAINLESS STEEL HINGES

f Hinge position is adjustable to fit a large selection of pan dimensions.
f Hinges can be fitted on the inside or outside of the seat as shown in the diagrams below.
f Adjust the hinges to fit the seat in the correct position on the pan.
f Ensure the pins of the hinges are all the way into the seat before securing the hinges. Failing to do so could
cause damage to your seat. Please ensure that the seat is secure before use.
A
B
A
C
B
C
OR
A - Fixing Centres: 125-195 mm
B - Width maximum: 375 mm
C - Length maximum: 450 mm
• 4 buffers on seat
• 4 buffers on lid
f NOTE the different hinge option positions for different length pans
A
A
A
OR
B
A
OR
B
B
STOP SEAT
MOVEMENT
A
f holds the seat in place!
OR
B
OR
C
A
B
A
A
OR
A
OR
B
OR
B
A
OR
A
B
OR
OR
B
OR
B
OR
B
C
OR
C
OR
OR
C
C
A