Assembly And Operation - Waldbeck 10031865 Manual

ASSEMBLY AND OPERATION

1. Make sure the power cord is disconnected from the socket (Fig1)
2. Loose Clips (Fig2)
3. Raise the nose assembly from the dust pan. (Fig 3)
4. Raise the filter assembly from the dust container. (Fig 4)
5. Remove the internal accessory. (Fig 5)
6. Check the filter components are complete, respectively, by the cyclone (1), the
cyclone (2) into the sponge (3), into the air gate (4), in order to show the order of
assembly. (Fig 6)
7. Load the assembled cyclone assembly into the dust pan. (Fig 7)
8. Place the nose assembly on a dust bucket that already has a filter assembly and
lock it with both sides of the buckle. (Fig 8)
9. Insert the hose rack into the corresponding position on the head assembly. (Fig 9)
10. Insert the handrail into the corresponding position on the top cover. (Fig 10)
1 1. Align the hose assembly port with the suction port, insert it and rotate it to the right.
(Fig 1 1)
12. Two tube and hose assemblies can be selected for installation. The two tube
diameter of the big end of the force in place. (Fig 12)
13. Optional brush and two tube installation. Will be one end of the brush to plug in
place. (Fig13)
EN
19