Page 1
Installation Instruction V1.0 HNSS6 Thank you for choosing our product! We strive to provide the best quality and services for our customers. Would you kindly share your experience on Amazon if you are satisfied? Should you have any issues, please don't hesitate to contact us.
Page 2
Severe personal injury and property damage can result from improper installation or assembly. Read the following warnings carefully before beginning. IMPORTANT SAFETY INFORMATION ● Products must be installed by a qualified installer. ● If you do not understand the instructions or have any concerns or questions, please contact a qualified local installer.
Page 3
Parts and Hardware Included M4x12 M5x12 M6x12 (4mm) (5mm) A (4pcs) B (4pcs) C (3pcs) Step 1 Installation Method A. Table Edge Installation (5mm) (4mm) 10~95mm Warning: Ensure screws are secured firmly.
Page 4
Warning: Ensure screws are secured firmly. B. Grommet Installation Warning: Warning: (4mm) Ensure screws are Ensure screws are secured firmly. secured firmly.
Page 5
Full Adjustment After Installation 0~95mm 0~95mm For table edge For grommet Load Range: 4.4~14.3Ibs (2~6.5kgs) Step 2 Directional Usage Guide Non-proper usage Proper usage directions ( Not ok) directions (ok)
Page 6
Step 3 Power and Display Lines Installation USB line Power line Display line...
Page 7
Step 4 Display Installation Warning: Ensure screws are secured firmly. Step 5 Torque Adjustment “+”: Torque increase direction shown in fig Torque decrease direction shown in fig “-”: (5mm) Notes:Ensure display weight is within load range.
Page 8
1.If display can be hovered at any height after display installed.No adjustment needed. 2.If display lifts up automatically after installation, adjust the following: One people hand presses down the screen, while the other one winds set screw at the bottom of upper arm at joint to ' – ' direction to reduce torque by using F, 5mm Allen key as shown in Figure ①...
Page 9
Step 8 Display Rotation 360° Only display that comes with central gravity will has the best performance. TESTION ADJUSTMENT SHOULD BE DONE ONLY AFTER MOUNT INSTALLATION Do not adjust tension without display. 1.Ensure display has been attached to the mount. 2.Read your display packaging or manual to find out display net weight.
Need help?
Do you have a question about the HNSS6 and is the answer not in the manual?
Questions and answers