Advertisement
NORMAL BLUE.
5. Use the MENU LEFT/RIGHT keys to adjust the value of NORMAL RED,
NORMAL GREEN, or NORMAL BLUE.
6. When all desired changes to the WHITE TONE submenu values are made, press
the MENU button to return to the top-level SDAM menu.
7. To ensure the WHITE TONE settings are saved:
• Turn the television set OFF by using the POWER button on the remote
control transmitter or the local keyboard.
• Disconnect the television set from AC power for at least ten seconds.
• Reconnect the television set to AC power.
• Turn the television set ON by using the POWER button on the remote
control transmitter or the local keyboard.
Geometry
The geometry alignments menu contains several items for correct picture geometry
alignment.
1. Connect the RF output of a video pattern generator to the antenna input.
2. Input a crosshatch test pattern to the television set.
3. Set the amplitude of the video pattern generator to at least 1mV and set the
frequency to 61.25MHz (channel 3).
4. Press the AUTO PICTURE button on the remote control transmitter repeatedly to
choose PERSONAL or MOVIES picture mode.
5. Enter SDAM:
• Press the following key sequence on the remote control transmitter:
0-6-2-5-9-6-MENU
• Do not allow the display to time out between entries while keying the
sequence.
6. Use the MENU UP/DOWN keys to highlight the GEOMETRY sub menu.
7. Press the MENU LEFT/RIGHT keys to enter the GEOMETRY sub menu.
8. Use the MENU UP/DOWN keys to highlight either the HORIZONTAL sub menu
or the VERTICAL sub menu.
9. Press the MENU LEFT/RIGHT keys to enter either the HORIZONTAL sub menu
or the VERTICAL sub menu.
Advertisement
