Grease Filter; Replacing The Oven Light - Zanussi ZBF 860 Instruction Booklet

Grease Filter

To prevent a build-up of fats on the fan impellor, the
grease filter must be fitted by clipping it over the
vents in the back panel.
To clean the grease filter
When the oven has cooled down, remove the filter by
pushing the protruding tongue on the filter upward,
and wash carefully.
The grease filter should be cleaned after every use.
The filter may be washed in a dishwasher on a 65 C
wash. If the filter is heavily soiled, place the filter in a
saucepan of water with approximately 1 teaspoon of
automatic washing powder or dishwasher powder.
Bring to the boil and leave to soak for approximately
30 minutes or longer depending on the degree of
soiling. Ensure the solution does not boil over as it
could mark your hob.
Rinse filter in clear water and dry.
Remember to refit the filter before using the oven
again.

Replacing the Oven Light

If the oven bulb needs replacing, it must comply with
the following specifications:
- Electric power: 15W,
- Electric rate: 230-240 V (50 Hz),
- Resistant to temperatures of 300 C,
- Connection type: E14.
These bulbs are available from your local Zanussi
Force Service Centre.
To replace the faulty bulb:
1. Ensure the oven is isolated from the electrical
supply.
2. Turn the glass cover anticlockwise.
3. Remove the faulty bulb and replace with the
new one.
4. Refit the glass cover.
5. Restore the electrical supply.
18
FO 0018
FO 0287