Advertisement
[ ]
Tap the 11/16" and 2 3/4" hole locations with the 4-40 tap.
[ ]
Remove the PEX plug with the screw assembly attached and set aside. Remove the 3/4"
copper pipe plug from the PEX tubing and install the BNC male chassis connector on the
outside, securing the nut on the inside. Use a socket if available. It is not necessary to use the
solder lug supplied.
[ ]
Tin the end of the of the supplied 22awg magnet wire, with solder 1/4", and feed thru the
PEX tubing at the 1 1/8" location hole to the inside as shown, and solder it to the center
connection of the BNC chassis connector.
Page 4 of 10
Tap those locations
only.
ds1_antenna_assy_072920.pdf
Advertisement
