Table of Contents
Advertisement
11
Securing screws for sealed-
beam unit retaining ring.
Loosen securing screws, re
move retaining ring and unit.
Pull off connector.
12
Securing screws for fog lamp
retaining ring. Loosen secur
ing screws and take out lamp
body. Pull off plug (13). Disen
gage retaining spring and re
move bulb (14).
15
Bulb for turn signal, parking,
side marker and standing
lamp. Loosen fastener (6).
Push lamp body forward and
detach. Hold lamp holder by
8 8 8 2
the wide lug and pull out.
Depress bulb, turn to the left
and take out. When installing
the bulb holder, the lugs must
engage the lamp body reces
ses. When installing the lamp
body, never fail to engage the
locating webs (16) between
the retaining springs (17).
Tail Lamp Assemblies
1
Turn signal lamp
2
Stop lamp
3
Tail lamp, standing lamp,
side marker lamp
Electrical System
Loosen both securing nuts in the car
go space but do not unscrew comple
tely. Loosen tail lamp assembly by
exerting even pressure on both nuts.
Unscrew securing screws completely
and detach tail lamp assembly.
Push up the securing lug of the lamp
holder slightly and remove lamp
holder.
To replace, depress bulb, turn it to
the left and pull it out.
71
Advertisement
Table of Contents
