Maintenance - Hatsan USA TactAir Volt Operation Manual

6. MAINTENANCE

This is a low-maintenance product, however, it is not "maintenance-free". Proper use and
maintenance of your Volt Compressor is critical to its longevity. Failure to properly maintain
your compressor will result in premature failure, and may void your warranty.
• Use only approved filters, hoses, fittings, and accessories. It is your responsibility to check
for leaks before using to fill.
• To reliably produce clean air, the filter must be monitored on a regular basis and changed
when necessary. Filter life will vary due to many factors, including but not limited to:
humidity, temperature, purge frequency, and cycle times.
• Parts of this compressor can become hot enough to cause burns. Do not operate the
compressor without all its protective panels in place, and do not touch or cover the
ventilation openings or handle the compressor at any time during or immediately after
operation. It is advisable to allow the compressor to cool before handling or moving after
it has been used.
Leak Checks
• Perform a System Leak Test every 30 hours of runtime or every six months – whichever
occurs first.
o Additionally, perform a System Leak Test any time the compressor is unused for
more than three months.
Filters and Desiccant
• Replace the cartridge filter and/or desiccant media every six months or anytime
moisture begins to be expelled from the fill whip.
• An additional inline filter may be desired when operating in very humid environments,
or simply as additional moisture protection for your airguns.
• An optional inline filter is available from HatsanUSA, which can be filled with desiccant
to decrease the amount of moisture transferred though the fill whip.
Voltage Selection
• The AC voltage input selector switch is accessed through an opening on the left side of
the compressor body. The default input voltage selection is 115V AC for standard US
household outlets.
o Leave or place the switch in the UP position for use with 115V AC outlets.
o Place the switch in the DOWN position for use with 230VA AC outlets.
8