EM-3080J / EM-3080J-2M
Thank you for purchasing brushless motor.
Brushless motors are required to drive E3200 Series spindles with NE260 Control unit.
Please read this operation manual carefully prior to use.
1
CAUTIONS IN OPERATING
Read these cautions carefully and only use in the manner intended.
Safety instructions are intended to avoid potential hazards that could result in personal
injury or damage to the device. Safety instructions are classified as follows in
accordance with the seriousness of the risk.
Class
Existence of a hazard that could result in bodily injury or damage to the
WARNING
device, if the safety instructions are not followed.
Possibility of a hazard that could result in light to medium degree of bodily
CAUTION
injury or damage to the device, if the safety instructions are not followed.
WARNING
1
NAKANISHI product's are intended for use by trained, knowledgeable, highly
experienced professionals only.
Brushless motors are not designed as a hand tool. Install it on a machine such as a
2
lathe or special purpose machine.
3
Do not touch the spindle during rotation.
Wear safety glasses, dust mask and hearing protection and use a protective cover
4
around the spindle whenever spindle is operating.
5
When installing a motor/spindle to a fixed base, make sure the fixed base is
grounded in order to avoid the risk of an electric shock.
Never touch the power cord by your wet hand. This may cause electric shock.
6
7
Never operate or handle the product until you have thoroughly read the owner's
manual and safe operation is confirmed.
.
Handle or operate the product only after sufficient precautions to prevent injury
have been taken and safety is confirmed.
.
Prior to operating the product confirm that all of the above safety precautions have
been taken. Do not connect the product to an energy source or supply compressed
air until all safety checks have been confirmed.
Brushless Motor
Degree of Risk
OM-K0586E
1