Related Manuals for SentexSystems Clikcard-SA
Summary of Contents for SentexSystems Clikcard-SA
- Page 1 Doc - 6001131 Rev - B BASIC PROGRAMMING AND USE INSTRUCTIONS FOR THE Clikcard-SA SYSTEM...
- Page 3 IMPORTANT NOTICE This manual describes the basic system functions that need to be programmed for the Clikcard-SA system to function properly. If you wish to program the system’s more advanced features (i.e. time zones, automatic lock/unlock schedules, baud rate speed, etc.), please refer to the enclosed manual titled “USING THE MORE ADVANCED FEATURES OF THE Clikcard-SA SYSTEM”.
- Page 4 (so you do not accidentally leave it in the program mode). 3. The Clikcard-SA system provides visual feedback as you program. If you make an “error”, the system will display the following:...
- Page 5 2 - ENTERING AND EXITING PROGRAM MODE The sequences described in this section allow you to enter and exit the program mode, as well as to change the code that must be used to gain access to this mode. ENTERING PROGRAM MODE Format “...
- Page 6 If you want a transmitter to activate relays 2 and 3 or if you want to restrict the access of a specific transmitter to specific times or days, please refer to section 5 of the enclosed manual titled “USING THE MORE ADVANCED FEATURES OF THE Clikcard-SA SYSTEM.” ENTERING A GROUP OF TRANSMITTERS Purpose Allows you to load a group of transmitter numbers to open relay 1 only in one easy step rather than loading each transmitter individually.
- Page 7 4 - VERIFYING ENTRIES The steps in this section will allow you to verify the transmitters that are currently programmed in your system. VERIFYING A TRANSMITTER NUMBER Purpose Allows you to verify if a transmitter has been programmed into the system. Format 18 + transmitter number (up to 5 digits) + “#”...
Need help?
Do you have a question about the Clikcard-SA and is the answer not in the manual?
Questions and answers