Advertisement
7. OPERATION
I.
According to standard accident prevention precautions
Wear approved safety clothing in good condition and, in particular, overalls or other comfortable garments, sized
to prevent the risk of entanglement in moving machinery. Wearing anti-slip rubber boots is highly recommended.
The operator is responsible for the correct use, adjustment, cleaning and maintenance of the machine. The
operator should be professionally qualified with specific training or experience in the use of shape-milling
equipment, and capable of recognizing and preventing possible dangerous situations while using the machine.
II.
Starting the machine
•
Fasten the slab, the weight of the machine could overturn the slab.
•
Fasten the appropriate tool to the machine using the wrenches and bolts supplied, by fitting the tool (22.2mm
hole diam.) onto the spindle. Make sure that it firmly contacts the shoulder of the spindle shaft.
•
Open the water, back valve completely, front valve only slightly to cool the tool, opening too much could stop
the aquaplaning system to work properly and make scratches on the slab. While working the water stream
should follow the clockwise rotation of the tool.
•
Start machine and adjust the tool: Rotate the knob in a clockwise direction to raise, and counterclockwise to
lower the tool. ONLY adjust the tool by turning spindle, to avoid damaging the adjusting system.
•
The operator should control the machine using two hands, one on the front and one on the rear handle.
8. MAINTENANCE AND CLEANING
Clean the machine after work. Improper maintenance or lack of maintenance could cause injures to the operator
and bystanders. Repair defects promptly, before the machine is used again.
I.
Daily maintenance
General cleaning of the machine on a daily basis is recommended. Wash carefully with a damp sponge (do not use
any corrosive or flammable agents).
II.
Monthly maintenance
•
Inspect the belt and, if necessary, tighten it by adjusting the bolts placed on the motor-mounting plate. Be
sure to retighten bolts before operating the machine.
•
Check the condition of the machine and replace any damaged or worn parts.
•
Clean the water filter as unwinding the upper part and rinse the filtering net.
3
Advertisement
