Table of Contents
Advertisement
FROM
( ) R83-2 (s1)
( ) R84-2 (s1)
( ) R82-2 (s1)
( ) R84-1 (s2)
Four resistors are mounted directly on the solder lugs of the
potentiometers and jacks. Install the resistors by pushing their
leads through the lugs and "dressing" the part so that it's leads
do not touch the body of the pots or any lugs to which they do
not connect. Cut the leads off so they extend about 1/8"
beyond the lug and crimp them to the lug to hold the part in
place. Follow the soldering instructions as with the previously
installed wiring.
DESIG.
VALUE
( ) R75
1500 ohms
( ) R76
1500 ohms
( ) R85
270 ohms
( ) R86
270 ohms
The Gate LED (D15) and it's associated current limiting resistor R78
wire directly to the solder lugs of J2 as shown in fig 3. Locate the
LED and 3900 ohm resistor (orange-white-red). Cut the cathode
lead of the LED (closest to the orienting flat on the case) and one
lead of the resistor to a length of 1/2". Loosely twist these two leads
together and solder as shown.
( ) Push the lens of LED D15 through the hole provided for it in the
control panel as shown in fig 3. Connect the free end of R78
to lug "S" of J2 and SOLDER the THREE wires as this lug.
( ) Connect the anode (free lead) of D15 to lug "T" of J2
but DO NOT SOLDER this connection at this time.
Similarly, the POWER LED (D16) and R77 wire to the lugs of Switch
S1. Locate the LED and 2200 ohm resistor (red-red-red). As with
D15 above, cut the LED cathode lead and one lead of the resistor
short, twist them together and solder.
062702
TO
LENGTH
J5-T (ns)
10-3/4"
J3-T (ns)
4-1/4"
J4-T (s1)
2-3/4"
J6-S(s1)
10-1/2"
COLOR CODE
brown-green-red
brown-green-red
red-violet-brown
red-violet-brown
From
To
J5-S (ns)
R79-1 (ns)
J5-S (s3)
R80-1 (ns)
R79-1 (s2)
R79-3 (ns)
R80-1 (s2)
R80-3 (ns)
Theremax
15
Advertisement
Table of Contents
