Advertisement
Kit Assembly Instructions (Double DIN)
Double DIN Mount Applications
1. Remove the Shaded tab from the back edge of each left and right mounting bracket (right side not shown). FIG 2
2. Attach the left and right side brackets to an ISO mountable radio using screws provided with radio when possible or hardware
included with kit. FIG 3
3. Insert kit and radio into dash. Line up with the factory mounting point. Secure to the dash using the factory 7mm bolts.
FIG 2
Installation of the PAC HVAC control panel
Vehicles equipped with Non-MyLink radios
1. Connect the RPK5-GM4101-KIT-HAR to the vehicles white 20 pin connector that was originally connected to the factory HVAC
control panel.
2. Connect the 8 pin Black Micro-fit Molex connector to the circuit board mounted to the back side of the PAC HVAC control
module.
3. Tape up or remove the loose Orange/Black and Pink/Black wires as they are only needed for applications where the vehicle
was factory equipped with the touchscreen MyLink radio.
3. Fit the PAC HVAC control panel into the vehicle opening and secure at the bottom using the factory mounting hardware.
4. Assemble the remaining pieces of the dash.
Installation of the PAC HVAC control panel (cont.)
Vehicles equipped with MyLink radio
1. Connect the RPK5-GM4101-KIT-HAR to the vehicles white 20 pin connector that was originally connected to the factory HVAC
control panel.
2. Connect the 8 pin Black Micro-fit Molex connector to the circuit board mounted to the back side of the PAC HVAC control
module.
3. Locate the Orange/Black (Pin 15) and Pink/Black (Pin 19) wires in the 27 Pin Lt. Blue connector at the Body Control Module
(BCM). The BCM is located under the driver side of the dash.
4. Connect the loose end of the Orange/Black extension wire to the Orange/Black wire in Pin 15.
5. Connect the loose end of the Pink/Black extension wire to the Pink/Black wire in Pin 19.
6. Route both of the extension wires to the right and through the same opening that the White 20 pin connector passes through
and connect them to the bullet connectors on the RPK5-GM4101-HIT-HAR. Be sure to not route these wires near any moving
parts as it could cause damage to these wires in the event they become pinched.
7. Fit the PAC HVAC control panel into the vehicle opening and secure at the bottom using the factory mounting hardware.
8. Assemble the remaining pieces of the dash.
Picture of the BCM which is located under the driver side of the
Pacific Accessory Corporation
dash just above the steering column
Pacific Accessory Corporation
©2016 Pacific Accessory Corporation
FIG 3
| 866-931-8021 | support@pac-audio.com
®
www.pac-audio.com
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
Close up of the Lt. Blue
connector located at the BCM
UNLESS OTHERWISE SPECIFIED:
FINISH:
DEBUR AND
DIMENSIONS ARE IN MILLIMETERS
BREAK SHARP
SURFACE FINISH:
EDGES
TOLERANCES:
LINEAR:
ANGULAR:
NAME
SIGNATURE
DATE
TITLE:
DRAWN
A
CHK'D
APPV'D
MFG
MATERIAL:
DOUBLE
Q.A
DWG N
WEIGHT:
SCALE:
PAC is an AAMP brand
Rev. 061716
Page 8
Advertisement
