Page 1
4.) Longer jumper cables may be sleeved through PVC (1”), EMT or Wire Mold if desired. 1. Confirm All Components Received A.) Supplied Materials B.) Required Materials -WPX Series Luminaire(s) -Mounting Screws (depending on mounting surface) -WPX 48V Power Supply(s) -Leader Cable(s) with End Cap(s)
Page 2
T 800.285.6780 E sales@ggled.net www.ggled.net INSTALLATION MANUAL PAGE 2 2. Verify Electrical Plan & Power Supply Load Verify the fixture layout, power supply and maximum load, using the tables below. Max Load Max Load Power Supply Enclosure Input Voltage Standard Output (SO) High Output (HO/Color) WPX-PSU-600 (600W) IP67 (Indoor/Outdoor)
Page 3
INSTALLATION MANUAL PAGE 3 3. Mount Fixtures WPX series wet location fixtures are typically surface mounted (Ceilings, Walls, etc). If mounting on the ceiling, it is recommended to keep the fixtures 2-3 feet in from the wall. Mark the clip locations. If possible, use a chalk line and snap a line down the entire length of the run, where the fixtures are intended to be mounted.
Page 4
T 800.285.6780 E sales@ggled.net www.ggled.net INSTALLATION MANUAL PAGE 4 5. Connect Fixtures Together Install the jumper cables between the mounted fixtures. The 1FT jumper (WPX-JMP1) may be looped for minimum distance between fixtures. Longer cables may be sleeved through PVC, EMT, or wiremold if desired. Figure 5.1: Fixture Jumper 6.
T 800.285.6780 E sales@ggled.net www.ggled.net INSTALLATION MANUAL PAGE 5 8. Connect 0-10V Dimming Source (If Equipped) Only fixtures marked with a “-DIM” sticker are capable of being dimmed. G&G LED fixtures may be connected to all standard 0-10V dimming sources, such as wall dimmers, occupancy sensors, and lighting controllers. Please contact G&G Support with any compatibility or hookup questions.