Advertisement
The glass dishes are restrained in three removable
retainer panels.
The panels are removable to provide easy cleaning
and to allow you to place your own serving dishes in
this space, should you wish.
(The removal and fitting of these panels is detailed
below.)
DISH RETAINER – REMOVAL AND FITTING
Note: it is best to remove the middle retainer first
when removing the three retainers, and best to refit
the end retainers first when refitting them.
To remove the dish retainers, proceed as follows:
•Remove the dishes from their retainers.
•Remove the retainers by pulling them vertically out
of the trolley while keeping them as level as possible.
Once removed, the heated surface under the leaves
can be cleaned or used for you to place your own
serving dishes.
To refit a dish retainer:
•Insert it into the space, keeping it horizontal.
•Align the two lines on the retainer with those on the
vertical walls of the space (see figure 1 on back
page). The retainer is fully fitted when the tags on the
retainer are fully engaged with their respective
pockets.
Replacement dishes and retainer panels can be
purchased from:
The Manufacturer,Hostess
Lightcliffe Factory
Hipperholme
Halifax HX3 8DE
Telephone 01422 203963
Fax 01422 206652
DOOR ADJUSTMENT
Every effort is made in the manufacturing process to
ensure the doors are correctly aligned before
dispatch.
All models except HL 6200 and HL 6232 are fitted
with adjustable hinges to allow realignment of the
doors if necessary (e.g. when the trolley is being used
on uneven floors).
The hinges used are of a common construction to
those found on kitchen, bedroom and dining room
furniture.
Refer to figures 2 and 3 on the back page.
To adjust the door in the lateral (X) direction:
•Slacken screws "A" half a turn.
•Adjust the lateral movement of the door by adjusting
screw "B".
Turning screw "B" clockwise forces the hinge away
from the side of the trolley and vice versa.
•Remember to retighten screw "A" after the
adjustment is complete.
To adjust the door in the frontal (Y) direction:
•Slacken screws "A" half a turn.
•Adjust the door to the desired position by pushing
the hinge towards the back of the trolley or pulling
the hinge towards the front of the trolley.
•Remember to retighten screw "A" after the
adjustment is complete.
To adjust the door in the vertical (Z) position:
•Slacken screw "C" on both hinges half a turn.
•Adjust the door to the desired position by lifting the
door up or pushing it down.
•Remember to retighten the screws after the
adjustment is complete.
CLEANING
Use a soft, damp cloth (with some detergent, if
required) and/or a squeezed out sponge for cleaning.
Do not use scratching and scouring cleaning agents,
scourers, wire wool etc.
Always remember the following points:
•Remove the mains plug from the wall socket before
cleaning the appliance.
•Prevent water from running into the appliance.
•Cleaning is easiest when the appliance has cooled
down but has not yet become really cold.
The removable retainers and the serving dishes can
be washed.
The serving dishes are safe to wash in a dishwasher.
Advertisement
