Totem Rainmaker Manual page 11

CLAW INSTALLATION INSTRUCTIONS
Start by positioning the speaker on the top portion of the cabinet. Take precaution to protect the finish
by using the packaging foam end cap to secure your speaker prior to installation.
Insert a screw into a single Totem Claw and position the assembly (screw and claw) over the pre-drilled
hole; the screw will serve as a guide to find the pre-drilled hole. The Totem Claws should be positioned
on each rear side of the speaker and one centered in front.
Using the appropriate screwdriver or low speed drill, with proper bit, screw in the fastener carefully
while firmly pushing the Totem Claw flush against the front speaker surface, making full contact with the
wood surfaces. Repeat the procedure for all 3 Totem Claws and speakers. Position the speaker on its
claws after finding the appropriate room location. Insert the self–centering ball bearing underneath the
Totem Claw. The Claws can be used with or without the ball bearings depending on the floor surface.
Claw
screw
Round Hex Head Socket Screw-M5X30
11
totemacoustic.com