Operation - Poulan Pro PP130 Instruction Manual

ADJUSTING THE HANDLE
CAUTION:
When adjusting the handle, be
sure it remains above the safety label and be-
low the mark or arrow on the shaft.
KNOW YOUR UNIT
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR UNIT.
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Trimmer head
Shield
Line limiter
blade
Throttle trigger
ON/STOP SWITCH
The ON/STOP switch is used to stop engine. To
stop the engine, move the switch to the STOP
position.
PRIMER BULB
The PRIMER BULB removes air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
BEFORE STARTING ENGINE
WARNING:
information in the safety rules before you be-
gin. If you do not understand the safety rules,
do not attempt to fuel your unit. Call
1-800-554-6723.
FUELING ENGINE
WARNING:
when refueling.
HELPFUL TIP
To obtain the correct oil mix
ratio, pour 3.2 ounces of
2- - cycle synthetic oil into
one gallon of fresh gas.
IMPORTANT:
This equipment is designed to
operate on unleaded gasoline with a minimum
87 octane (R+M/2 method), with ethanol blen-
ded up to 10% maximum by volume (E-10). Be-
fore operation, gasoline must be mixed with a

OPERATION

Coupler
Shaft
Throttle lock- -out
Be sure to read the fuel
Remove fuel cap slowly
1. Loosen wing nut on handle.
2. Rotate the handle on the shaft to an up-
right position; retighten wing nut.
ON/STOP switch
Assist handle
Choke lever
Primer bulb
CHOKE
The CHOKE helps to supply fuel to the engine
to aid in cold starting. Activate the choke by
moving the choke lever to the FULL CHOKE
position. After the engine attempts to start, move
the choke lever to the HALF CHOKE position.
Once engine has started, move the choke lever
to the RUN position.
COUPLER
The COUPLER enables optional attach-
ments to be installed on the unit.
good quality synthetic 2-cycle air-cooled engine
oil designed to be mixed at a ratio of 40:1.
Poulan/WEED EATER brand synthetic oil is re-
commended. Mix gasoline and oil at a ratio of
40:1. A 40:1 ratio is obtained by mixing 3.2 fluid
ounces of oil with 1 gallon of unleaded gasoline.
DO NOT USE automotive oil or marine oil.
These oils will cause engine damage. When
mixing fuel, follow instructions printed on con-
tainer. Once oil is added to gasoline, shake con-
tainer momentarily to assure that the fuel is thor-
oughly mixed. Always read and follow the safety
rules relating to fuel before fueling your unit. Pur-
chase fuel in quantities that can be used within
30 days to assure fuel freshness.
CAUTION:
your unit. This will cause permanent engine
damage and void the limited warranty. Do not
use alternate fuels such as ethanol blends
above 10% by volume (E-15, E-85) or any
methanol blended fuel. Use of these fuels can
cause major engine performance and durability
problems.
10
Muffler
Starter handle
Never use straight gasoline in