Garmin Montana 7 Series Installation Instructions Manual page 3

Installing the Handlebar Base
The device includes parts for two handlebar installation
solutions. Custom mounts may require additional hardware.
Installing the U-bolt and Handlebar Base
1
Place the U-bolt around the handlebar
ends through the handlebar base
2
Tighten the nuts to secure the base.
NOTE: The recommended torque is 50 lbf-in (5.65 N-m). Do
not exceed torque of 80 lbf-in (9.04 N-m).
Installing the Handlebar Base to the Clutch-Clamp or Brake-
Clamp Brackets
1
Remove the two factory bolts on your clutch-clamp or brake-
clamp bracket .
NOTE: Both 1/4 in. standard and M6 bolts are included.
Match the size of the factory bolts on your clutch-clamp or
brake-clamp bracket.
2
Thread the new bolts
, and clutch-clamp or brake-clamp bracket.
3
Tighten the bolts to secure the base.
Attaching the Base Plate to the Motorcycle Mount
Direct, sustained contact with the base plate, or any part of the
motorcycle, may damage the mount over time. To prevent this
kind of damage, you must place the mounting spacers between
the mount and base plate, and make sure that no part of the
device or mount touches the motorcycle.
1
Thread the M4 x 20 mm panhead screws
washers , cradle, bushings, spacers
2 Tighten the nuts to secure the base plate.
Installation Instructions
, and thread the
.
through the handlebar base, spacers
NOTICE
through the
, and base plate
Attaching the Base Plate to the Handlebar Base
1 Align the ball of the handlebar base
base plate with each end of the double-socket arm
2
Insert the ball of the handlebar base
base plate into the double-socket arm
3
Tighten the knob slightly.
4
Adjust for optimal viewing and operation.
5
Tighten the knob to secure the mount.
Specifications
Fuse
Input voltage
Input current
Input current without device
installed
Operating temperature range
Limited Warranty
The Garmin standard limited warranty applies to this accessory.
For more information, go to www.garmin.com/support/warranty.
.
and the ball of the
and the ball of the
.
3 A
10 to 30 V
1.5 A Max.
0.5 mA Max.
From -20º to 60ºC (from -4º to 140ºF)
.
3