1. Manuals
  2. Brands
  3. TEC Electronics Manuals
  4. Control Unit
  5. FanControl-U2
  6. Technical manual

TEC Electronics FanControl‑U2 Technical Manual

Hide thumbs
Table of Contents

Advertisement

Quick Links

FanControl‑U2
Technical manual
www.tecel.ru

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FanControl‑U2 and is the answer not in the manual?

Questions and answers

Related Manuals for TEC Electronics FanControl‑U2

Summary of Contents for TEC Electronics FanControl‑U2

  • Page 1 FanControl‑U2 Technical manual www.tecel.ru...

  • Page 2: Table Of Contents

    FanControl-U2 module Technical manual of Contents 1. Description of the module ....................2 2. Connection and configuration of the module ................3 Тable 1. Module connector pins designation ..............3 Before installation ......................4 Module programming ......................4 Operation mode indication ....................4 Тable 2. LED indication......................4 Intefacing module with a vehicle ..................5 Connection to CAN bus .....................5 Module control ........................5...

  • Page 3: Connection And Configuration Of The Module

    FanControl-U2 module Technical manual of Activation of vehicle’s factory heater. Activation of heater and the climatic system for engine and interior warm-up using vehicle’s factory button or factory remote control. Control of Webasto Thermo Top C, Evo 5, Eberspächer D5WS heaters via digital bus. Support of heat-assistance mode.

  • Page 4: Before Installation

    FanControl-U2 module Technical manual of Before installation • Carefully read this technical description • Check whether the module is compatible with the designated vehicle and make sure that the required functions are supported by the module. Module programming The module is equipped with a micro-USB port which is used for connection of the module to a PC via a micro-USB cable allowing to carry out programming and adjusting various settings of the module by means of a special software which is called TECPROG (available for download at www.

  • Page 5: Connection To Can Bus

    FanControl-U2 module Technical manual of Vehicle Identification Identification is performed via TECPROG software or manually by using the built-in button. Description of manual identification using of the built-in button: CAN bus should not be connected prior to implementation of the identification procedure. Power up the module.

  • Page 6: Programming Sequence

    FanControl-U2 module Technical manual of Switch the module on/off with the external input Status control Trigger control Input #11 Input #9 Оn FanControl FanControl To restart the module via input #11 it is necessary to switch off the “status” signal and then activate it again.

  • Page 7: Heater Operation Time

    FanControl-U2 module Technical manual of Menu Factory Menu Note code default Delay prior to climatic 1 – 5 min; 2 – 10 min; 3 – 15 min; 4 — 20 min; system activation 5 — 25 min; 6 — 30 min Engine temperature to 1 —...

  • Page 8: Auxiliary Heater Mode

    FanControl-U2 module Technical manual of The default value is 3 (30 minutes). To exit the programming mode turn off the ignition or wait for 30 seconds after the last press on the programming button was made. The value of this option is ignored if the module is controlled via the status external control input №11 (pink/black).
  • Page 9 Product warranty period is 3 years from the date of purchase if installed according to the instructions. Please contact your vendor if you wish to make a warranty claim. Seller _____________________________ Date of purchase __________________________ Manufactured by TEC electronics The product is manufactured according to Technical Specification 4372-006-78025716-10.

Table of Contents