Makita DTW181 Instruction Manual page 8

the
the
housing
into
all
it
with
If
the
the
the
not
CAUTION:
Always install the battery cartridge
fully until the red indicator cannot be seen. If not, it
may
out
causing
or
CAUTION:
Do not install the battery cartridge
forcibly. If
not
it
inserted
Tool / battery protection system
The tool
a
This
cuts
the
tool
The
automatically
operation if
or
under one of the following conditions:
Overload protection
When the
in
causes
an
the
stops
indication. In
turn
application that caused the tool to become overloaded.
Then turn the tool on to restart.
Overheat protection
When the
overheated,
stops
this
tool/battery cool
tool on again.
battery cartridge with
groove in the
and slip it
place. Insert it
the way until
locks in place
a little click.
you can see
red indicator on
upper side of
button, it is
locked completely.
accidentally
of the
injury to
someone around
the cartridge
slide in
is not
correctly.
is equipped with
tool/battery protection system.
system automatically
off power to
motor to extend
and battery life.
tool will
stop during
the tool
battery is placed
battery is operated
a manner that
it to draw
abnormally high current,
tool automatically
without any
this situation,
the tool off and stop the
tool/battery is
the tool
automatically. In
situation, let the
before turning the
Overdischarge protection
When
Indicating the remaining battery
capacity
Only for battery cartridges with the indicator
►
button
Press
fall
tool,
you
you.
does
easily,
being
Lighted
NOTE: Depending on the conditions of use and the
ambient
Switch action
►
CAUTION:
cartridge into the tool, always check to see that
the switch trigger actuates properly and returns
to the "OFF" position when released.
To
8 ENGLISH
the battery capacity
not enough, the
stops automatically.
this case, remove
battery from the
and charge the
Fig.2: 1. Indicator lamps 2. Check
the check button
the battery cartridge
indicate the remaining battery
capacity. The indicator
light up for a few seconds.
Indicator lamps
Off Blinking
temperature, the
indication may differ
from the actual
Fig.3: 1. Switch trigger
Before installing the battery
start the tool,
pull the switch
Tool speed is
increased by increasing pressure
is
tool
In
the
tool
battery.
on
to
lamps
Remaining
capacity
75 % to 100%
50 % to 75%
25 % to 50%
0 % to 25%
Charge the
battery.
The
may
ba
malfunctioned.
slightly
capacity.
simply
trigger.