ASSEMBLY
Snap the Stabilization Foot into the back of the Register Base.
CAUTION:
Adult assembly required.
ATTENTION :
Ce jouet doit être assemblé par
un adulte.
GETTING STARTED
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the bottom of the unit, use a
screwdriver to loosen the screw
and open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AAA batteries
following the diagram inside the
battery box.
5. Replace the battery cover and
tighten the screw to secure.
Register
Base
Stabilization Foot
5