Byron DIC-24615 Instruction Manual page 5

K. Charge the battery (see 3.3.3) and place the battery in the
outdoor unit.
L. Place the front cover and fasten the screw at the bottom of the
outdoor unit to secure the cover.
3.3 ELECTRICAL INSTALLATION
3.3.1 Connecting AC power to the indoor unit
(monitor)
The monitor is portable and can be used on battery power, AC power
or both. When the AC adapter is connected the battery charges until
full and then operates directly from the AC adapter. Only use the
included AC adapter.
3.3.2 Installing and charging the indoor unit
battery
A. Open the battery cover on the back of the unit.
B. Check the label on the battery for the correct orientation.
C. Insert the battery and place back the battery cover.
D. Place the indoor unit on the charging dock.
E. Charge the battery completely before using the monitor on battery
power alone.
3.3.3 Charging outdoor unit battery
The outdoor unit (doorbell) can be operated on battery or AC power
(AC adapter not included). If operated on battery, it must be removed
in order to re-charge.
A. Remove the screw holding the front cover.
B. Remove the front cover.
C. Press the metal lever and pull out the battery pack.
D. Re-charge the battery by using the micro USB charge adapter
supplied for the monitor.
E. After charging: Insert the battery into the outdoor unit.
F. Place the front cover.
G. Fasten the screw holding the cover in place.
3.3.4 Connecting AC power to the outdoor
unit (doorbell) (adapter not included)
The outdoor unit is portable and can be used on battery power or AC
power. To use the outdoor unit on AC power you need an adapter of
8 – 24 V.
To connect the AC terminal blocks, you will need the following tool:
ü A small flat head screw driver.
A. ORANGE terminal block: Loosen the terminal screws.
B. With the terminal facing you: Insert the (+) wire on the left and the
(-) wire on the right.
C. Fasten the terminal screws.
Instruction manual
EN
5