Electrical Hazard - AirApp KK26D10060V Operating Instructions Manual

Lubricated compressor

Hide thumbs

Table of Contents

Available languages

PROBLEM

Ölverlust

OpERATING INSTRUCTIONS - SAFETY pRECAUTIONS:

Please familiarize yourself with the following information to prevent damage to your compressor unit and injury to the

operator.

ELECTRICAL HAzARD

Never use the compressor unless connected to a properly grounded outlet with the specified voltage and fuse pro-

tection. Do not use the compressor in a wet or explosive environment. Never attempt maintenance or adjustment with

power connected or the equipment in operation.

TANK SAFETY VALVE

This valve is factory installed to prevent the air receiver from damage should malfunction occur in the pressure switch.

It is factory set at a specific limit for your particular model, and should never be tampered with. Adjustment by user will

automatically void the warranty.

Do not remove, make adjustments to or substitute this valve.

pRESSURE SWITCH

The air pressure switch is set at the factory for optimum performance of your particular model. Never bypass or remove

this switch as serious damage to equipment or personal injury could result.

MOTOR AND COpRESSOR pUMp

The air compressor will get hot while in operation. Never touch the discharge tubing, motor or compressor pump while in

operation. The compressor operates automatically while the power is connected.

COMpRESSED AIR CAUTION

Compressed air from the unit may contain hazardous fumes. Air produced by this compressor is not suitable for brea-

thing purposes. Always use a respirator when spraying paint or chemicals, or when sandblasting. Always wear safety

glasses or goggles when using compressed air.

AIR RECEIVER

Over pressurizing the air receiver could cause personal injury or material damage. To protect from over pressurizing, a

factory per-set safety valve is installed.

Never weld, drill or change the air receiver in any way.

Be advised that any replacement parts should be purchased with the same specifications as the original equipment.

Please contact the authorized dealer for replacement parts or specifications.

MÖGLICHE URSACHE

Flasche Ölviskosität.

Zu viel Öl im Kurbelgehäuse.

Kompressor überhitzt.

Luftfilter verdreckt.

Abgenutzte Kolbenringe.

LUBRICATED COMpRESSOR

OpERATING INSTRUCTIONS

KORREKTURMASSNAHME

Ersetzen Sie das Öl gemäß der Empfeh-

lung in Abschnitt II durch nicht reini-

gendes Öl mit SAE-Vorgaben.

Öl ablassen und bis zum richtigen

Stand auffüllen.

Luftdruck zu hoch geregelt.

Luftfilter reinigen oder austauschen.

Kolbenringe ersetzen.

Table of Contents