Advertisement
3
2
1
8
5
7
1
m–6062
Figure 3
1. Mower
2. Chain
3. Chain Bolt
4. Push Arm
Preparing the Mower
1. Tip the mower upside down and block up ends to ease
installation of components.
2. Thoroughly clean the mower. All debris must be
removed to ensure baffles will fit properly against the
mower.
3. Repair all bent or damaged areas of the mower and
replace any missing parts.
Warning
Contact with sharp blade can cause serious
personal injury.
Wear gloves or wrap sharp edges of the blade
with a rag.
3
2
6
4
m–6265
5. Push Arm Bolt
6. Push Arm Nut
7. Push Arm Pin
8. Gage wheel
Removing the Cutting
Chamber Stiffener
Note: This section is only for mowers with a stiffener
welded to the cutting chamber (Fig. 4).
1. Remove the cutting chamber stiffener from the mower
(Fig. 4).
2. Grind the welds flat on rear part of the chamber. This
will allow the correct fit for the cutting chamber
baffle.
1
2
Figure 4
1. Cutting chamber
3
m–6081
2. Cutting chamber stiffener
Advertisement
