Accessories; Installation Procedure - Kenwood KCA-R71FM Instruction Manual

Accessories

External view
1
................................................2
2
................................................1
3
................................................1
4
................................................1
5
................................................1
The use of any accessories except for those provided might result in
damage to the unit. Make sure only to use the accessories shipped with
the unit, as shown above.

Installation Procedure

1. To prevent a short circuit, remove the key from the ignition and
Number of items
2. Make the proper input and output wire connections for each unit.
3. Connect the wiring harness wires in the following order: ground,
4. Install the unit in your car.
5. Reconnect the - battery.
6. Press the reset button.
2WARNING
When drilling a hole in the car chassis to install the unit, check
first that nothing is on the other side.
• If the fuse blows, first make sure the wires aren't touching to
• Do not let unconnected wires or terminals touch metal on the
• After the unit is installed, check whether the brake lamps,
• Insulate unconnected wires with vinyl tape or other similar
• Some disc changers require optional equipment for connection.
— 12 —
disconnect the - battery.
battery, ignition.
2CAUTION
cause a short circuit, then replace the old fuse with one with
the same rating.
car or anything else conducting electricity. To prevent a short
circuit, do not remove the caps on the ends of the
unconnected wires or the terminals.
blinkers, wipers, etc. on the car are working properly.
material.
See the section on "Safety Precautions" for details.