Table of Contents
Advertisement
Installation
Removing the hard rubber frame
1
Engage the catch pins on the removal tool and remove the tw o
locks on the low er level.
Low er the frame and pull it forw ard as show n in the figure.
Accessory 2 Removal tool
2
When the low er level is removed, remove the upper tw o
locations.
The frame can be removed from the top side in the same manner.
1
2
3
Catch
Lock
4
5
— 24 —
— 24 —
Removing the Unit
Refer to the section " Removing the hard rubber frame" and then
remove the hard rubber frame.
Remove the screw (M 4 × 8) on the back panel.
Insert the tw o removal tools deeply into the slots on each side,
as show n.
Screw (M 4X8)
(commercially
available)
Low er the removal tool
tow ard the bottom, and pull
out the unit halfw ay w hile
pressing tow ards the inside.
Be careful to avoid injury from the catch pins on the removal tool.
Pull the unit all the w ay out
w ith your hands, being
careful not to drop it.
Accessory 2 Removal tool
Advertisement
Table of Contents
