Kenwood KDC-4060RG Instruction Manual page 4

Safety precautions
N OTE
• If you experience problems during
installation, consult your Kenw ood dealer.
• If the unit does not seem to be w orking right,
try pressing the reset button first. If that does
not solve the problem, consult your Kenw ood
dealer.
AUD
35W x 4
DISP SCN RDM REP
ATT
Reset button
Cleaning the Unit
If the front panel gets dirty, turn off the
pow er and w ipe the panel w ith a dry silicon
cloth or soft cloth.
2CA U TION
Do not w ipe the panel w ith a stiff cloth or a
cloth dampened by volatile solvents such as
paint thinner and alcohol. They can scratch
the surface of the panel and/or cause the
indicator letters to peel off.
Cleaning the Faceplate Terminals
If the terminals on the unit or faceplate get
dirty, w ipe them w ith a dry, soft cloth.
Cleaning the CD Slot
As dust can accumulate in the CD slot, clean
it occasionally. Your CDs can get scratched if
you put them in a dusty CD slot.
CD
EJECT
PWR
OFF
NAME SET
MENU LOUD
T I CLK
VOL
ADJ
Lens Fogging
Right after you turn on the car heater in cold
w eather, dew or condensation may form on
the lens in the CD player of the unit. Called
lens fogging, CDs may be impossible to play.
In such a situation, remove the disc and w ait
for the condensation to evaporate. If the unit
still does not operate normally after a w hilst,
consult your Kenw ood dealer.
The marking of products using lasers
(Except for some areas)
— 4 —
CLASS 1
LASER PRODUCT
The label is attached to the chassis/case and
says that the component uses laser beams
that have been classified as Class 1. It means
that the unit is utilizing laser beams that are
of a w eaker class. There is no danger of
hazardous radiation outside the unit.