In Pu T Sen Sitiv Ity Cont Rol - Kenwood KAC-726 Instruction Manual

Controls
Operations of the follow ing control and sw itches are required in accordance w ith
the center unit and speakers connected w ith this unit.
KA C-7 2 6 1
KA C-5 2 6 X
KA C-7 2 6
KA C-5 2 6 X
1 RCA cable ground lead t erm inal
2 FILTER sw it ch
These switches allow filtering of the speaker output signals.
• LPF (Low Pass Filter) position
Only frequencies of 80 Hz or lower are output. (Frequencies above 80 Hz are cut.)
The Lch and Rch will be mixed before output even if the operation switch is set to STEREO.
• OFF position
The original sound without filtering is output.
3 OPERATION sw it ch
This switch allows selection of the amplification method of input signals.
• STEREO position
The amplifier can be used as a stereo amplifier.
• M ONO (Lch) position
Amplifies the signal input from the left side only. Set to this position and make bridged
connections to use as a high-power monaural amplifier. (The input right signal is not output.)

4 IN PU T SEN SITIV ITY cont rol

Set this control according to the pre-output level of the center unit
connected with this unit, or to the maximum power output of the genuine-
accessory car stereo.
Use the diagram on the right as a guide.
4
OPERATION
FILTER
OFF LPF STEREO MONO(Lch)
LINE IN
L
0.5 0.3
1.0
GND
MIN MAX
INPUT
SENSITIVITY(V)
2 3 4 5
POWER IN
GND
FUSE(20A x 2)
BATT P.CON(REMOTE)
7 8 9 0
POWER IN
GND
FUSE(15A) BATT P.CON(REMOTE)
7 8 9 0
SPEAKER LEVEL INPUT
LEFT RIGHT
R
6
BRIDGED
LEFT RIGHT
SPEAKER OUTPUT
POWER AMPLIFIER
!
BRIDGED
LEFT RIGHT
SPEAKER OUTPUT
POWER AMPLIFIER
!
10
0.5 0.3
15
1.0
MIN MAX
25
(W)