Operating Instructions; In Case Of Difficulty - Kenwood M-A300 Instruction Manual

Operating instructions

1
Sw itch the POW ER key to ON position.
2 Turn on the system by using the AV control
center.
3
Play a music source.

In case of difficulty

What appears to be a malfunction may not alw ays be serious. If your unit should not perform as expected, consult the table
below to see if the problem can be corrected before seeking help from your dealer or service representative.
Symptom
Sound cannot be produced.
(Indicator is off.)
Sound cannot be produced.
(Indicator lights.)
Sound is not produced from one of the
speakers.
Sound from the surround speaker is not
produced or very low .
Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform
the plastic components.
Note Note
Downloaded from: http://www.usersmanualguide.com/
POWER
-ON –OFF
• The parallel cord is not connected.
• The speaker cords are short-circuited.
• The protection circuitry is activated due to
internal temperature rise.
• The speaker cords are not connected.
• One of the speaker cord is not connected.
• A speaker cord is not connected.
• The pow er indicator on the panel lights up.
Cause
• Connect them properly referring to " System
• Turn the pow er OFF, remove the short-circuit,
• Sw itch the pow er OFF and w ait for the internal
• Connect them properly referring to " System
• Connect it properly referring to " System con-
• Connect it properly referring to " System con-
M -A3 0 0 / A1 0 0 (En)
Remedy
connections" .
and turn the pow er ON again.
temperature to drop. The unit can be turned
ON and re-used w hen the temperature drops,
but the fundamental solution of the problem
is not possible unless the unit installation
(heat radiation) condition is corrected. Im-
prove the unit installation referring to page 4.
connections" .
nections" .
nections" .
7