Accessory Installation - Titan TA-109 Operating And Service Manual

Accessory Installation

NOTICE: Unit accessories may
be larger than unit intake and
discharge opening or flanges.
Due to infinite
possibilities,
ductwork or transition may be
required for proper accessory
mounting (by others).
IMPORTANT:
SUPPORT accessory items from
a rigid point or points to ensure
solid mounting using field or
factory supplied hardware.
DESIGN CONSIDERATION:
Titan Air strongly recommends
using a flex coupler between the
AMU and Ductwork.
Refer to Field Wiring section, under the
installation section, for instructions on wiring the
damper actuators.
Design Requirement: If an intake hood is
supplied by others, the design shall minimize
entry of snow/ rain and include an intake screen
to meet ANSI standards.
Accessories on large equipment may be
shipped in two pieces for field assembly. As a
result, two damper actuators may need to be
field wired.
Horizontal Unit
Before beginning:
Verify with roofing manufacture the method
of installation preferred
accessories (Rooftop Equipment Only).
Locate assembly supplies:
Items included: Caulk, Support Brackets
(optional)
Field supplied hardware:
Caulk, Caulk Tape, Fasteners (Self tapping
screws and ¼ inch bolts/ nuts/ washers)
installation
a section of
Installer MUST
for supporting
HOOD
Support
(by others)
1. Match serial number on the accessory to
unit name plate inside control vestibule door.
2. Check unit submittal drawings to verify if
unit accessories need a transition to match up
with the air handler unit intake or discharge
opening.
19
AMU
FILTER
SECTION
Transition may be
required to interconnect
accessories and the
AMU (by others)