Curtis Dyna-Fog Golden Eagle 2610E Manual Addendum

Advertisement

Quick Links

Manual Addendum
For
TM
Golden Eagle
The following pages attached in this addendum should be
used instead of the manual when referring to components on
Golden Eagle™.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Golden Eagle 2610E and is the answer not in the manual?

Questions and answers

Summary of Contents for Curtis Dyna-Fog Golden Eagle 2610E

  • Page 1 Manual Addendum Golden Eagle The following pages attached in this addendum should be used instead of the manual when referring to components on Golden Eagle™.
  • Page 2 NOTE The method used for starting the engine will vary slightly depending on previous conditions of the machine. Regardless of which of the following conditions exist, the ignition switch must be depressed to restart the engine. DRY START: (Applies when the machine is first placed in service; when the machine has been allowed to run completely out of fuel;...
  • Page 3 STARTING THE ENGINE 1. Verify that the FORMULATION ON/OFF button is released and that the FORMULATION METERING VALVE has been rotated fully clockwise (CW) until the Stop is reached. 2. Lift the ON/OFF Control and place it in the "ON" position. WARNING DO NOT LEAVE THE MACHINE UNATTENDED WITH THE ON/OFF CONTROL IN THE ON POSITION, ESPECIALLY IF THE MACHINE HAS BEEN RUNNING.
  • Page 4 5. After setting the fog quality, the fog may be started and stopped by pressing and releasing the FORMULATION ON-0FF BUTTON. STOP FOGGING 1. When fogging is complete, release the FORMULATION ON-OFF BUTTON and rotate the FORMULATION METERING VALVE clockwise (CW) until the stop is reached. 2.
  • Page 5 2. Continue rotating the tool in the same direction and pull back and remove the brush from the tube. NOTE It is not normally necessary to push and pull hard on the brush handle; however, if the engine tube is not cleaned regularly, it becomes increasingly difficult to clean.
  • Page 6 111111 FIGURE 10...
  • Page 7 TANK-SIDE VIEW OF MACHINE REF. CURTIS PART NO. DESCRIPTION FIGURE 16 58522 Formulation Tank Ay. C58522 Formulation Tank A10105 Standpipe Connector A58523 Formulation Standpipe A85748 Elbow,⅛ MPT -¼T G195463 Nut, ¼ Tube G114628 Sleeve, ¼ Tube A21120 Union Elbow A21081-1 Plug, ⅛...

Table of Contents