Panasonic KX-FHD301 Service Manual page 27

2.2. USER RECOVERABLE ERRORS
If the unit detects a problem, one or more of the following messages will appear on the display.
DISPLAY MESSAGE
Note:
The explanations given in the [ ] are for servicemen only.
· There is something wrong with the unit.
· The document was not fed into the unit properly. Reinsert the document. If misfeeding occurs frequently,
clean the document feeder rollers and try again. (Refer to and DOCUMENT JAMS (P.28).)
· The film cartridge is not installed. Install it.
· Memory (telephone numbers, parameters, etc.) has been erased. Re-program.
· The recording paper is not installed or the unit has run out of paper. Install paper and press
clear the message.
· The recording paper is not fed into the unit properly. Reinstall paper and press
message.
· The recording paper has jammed near the recording paper entrance. Clear the jammed paper and press
to clear the message. Do not install folded or heavily curled paper.
(Refer to RECORDING PAPER JAM (P.29).)
· The cover is open. Close it.
· There is no space to store new items in the NAVIGATOR directory. Erase unnecessary items.
· The unit has a document in memory. See the other displayed message instructions to print out the
document.
· The memory is full of received documents due to a lack of recording paper or a recording paper jam.
Install paper or clear the jammed paper.
· When performing memory transmission, the document being stored exceeds the memory capacity of the
unit. Transmit the entire document manually.
· The film is empty. Replace the film cartridge with a new one.
· The film is slack. Tighten it and install again.
· When making a copy, the document being stored exceeds the memory capacity of the unit. Press
to clear the message. Divide the document into sections.
· There is something wrong with the modem circuit.
· The other party´s fax machine is busy or has run out of recording paper. Try again.
· A recording paper jam occurred. Clean the jammed paper.
[If the printout jams, please refer to RECORDING PAPER JAM (P.29).]
· The unit is checking that there is no slack no the ink film. Wait for a while.
· The other party´s fax machine is busy or has run out of recording paper. Try again.
· The document is jammed. Remove the jammed document.
· Attempted to transmit a document longer than 600 mm (23 5/8"). Press the
document. Divide the document into two or more sheets and try again.
· [Alternately, turn off service code #559 to enable sending of documents longer than 600 mm] (Refer to
DOCUMENT JAMS (P.28).)
· A transmission error occurred. Try again.
· The unit is too hot. Let the unit cool down.
CAUSE AND REMEDY
27
KX-FHD301
to
to clear the
to remove the