Advertisement
OPERATION
1. Block trailer wheels securely.
2. The Phoenix 4000 Electric Tongue Jack is oper‐
ated by means of the touch pad located next to
the motor housing.
3. Push ON/OFF button to turn jack on. The white
light will turn on and remain on until jack is
turned off by pushing the ON/OFF button again.
The jack and white light will automatically turn
off if no other buttons are pushed for five min‐
utes.
4. To extend jack, push & hold Extend Button.
5. To retract jack, push & hold Retract Button.
6. The GREEN light should turn on and remain on
while jack is in Extend/Retract operation.
7. If a steady RED light comes on in Extend/
Retract operation, a low voltage situation exits
and the battery needs to be fully charged.
8. If the RED light flashes quickly for three (3) sec‐
onds, a high amp situation exits and jack will
turn off after three (3) seconds. The jack will
reset itself in five (5) seconds and can be used
again until a high amp situation occurs.
A. The high amp draw situation can be
caused by too much load. Reduce the
tongue weight of the trailer.
B. The high amp draw can also be caused by
worn parts and the jack n eeds to be ser‐
PAGE 2
ULTRA‐FAB PRODUCTS, INC. 57985 SR 19 S ELKHART, IN 46517 (800) 860‐7571 www.ultra‐fab.com
PHOENIX 4000 ELECTRIC TONGUE JACK
viced and owner should call Ultra‐Fab for service op‐
tions.
9. Turn jack and white light off by pushing ON/OFF
button. Jack and light will automatically turn off if
no other buttons are pushed for five
AUTO‐EXTEND & AUTO‐RETRACT
The Phoenix 4000 Electric Tongue Jack has two new
features; Auto‐Extend and Auto‐Retract.
AUTO‐EXTEND: Allows user to extend the jack leg to
the ground without having to continually press and
hold the Extend button. This is especially helpful
when detaching RV from tow vehicle.
1. Initiate Auto‐Extend by pressing the Extend But‐
ton quickly two times. The jack will extend to the
ground and stop.
2. For whatever reason, the Auto‐Extend can be
cancelled by pressing any other button.
AUTO‐RETRACT: Allows user to retract jack leg with‐
out having to press and hold the Retract button. This
is especially helpful when user wants to attach RV to
tow vehicle.
1. Initiate Auto‐Retract by pressing the Retract But‐
ton quickly two times. The jack will retract to the
top limit and stop.
2. For whatever reason, the Auto‐Retract can be
cancelled by pressing any other button.
MANUAL OPERATION
1. Disconnect the fuse. (unscrew and pull apart)
2. Remove twist plug in the access hole. (located
top center of the housing cover)
3. Insert the supplied
over the drive hex head. Using your own socket
handle, rotate the socket clockwise to retract and
counter clockwise to extend.
4. When complete, remove socket and replace twist
plug, and reassemble the fuse connection.
IMPORTANT: Recalibration must be performed be‐
fore resuming normal operation. Or damage could
result.
P/N 38‐944040
US PATENT 10,252,591 B1
minutes.
9
/
" socket in the access hole,
16
rev 05032019
Advertisement
