Advertisement
WARNING
When using an extension wire, DO
NOT use smaller than #10 gauge
wire.
CAUTION
We do not recommend using the
flip‐up type footpad. Doing so
requires the tongue jack to be
altered which voids the warranty
and can cause the failure of the jack.
OPERATION
1. Block trailer wheels securely.
2. The Phoenix 5500 Electric Tongue Jack is
operated by means of the touch pad located
next to the motor housing.
3. To extend jack, push & hold Extend Button.
4. To retract jack, push & hold Retract Button.
5. The GREEN light should turn on and remain
on
while jack is in Extend/Retract operation.
6. If a steady RED light comes on in
Extend/Retract operation, a low voltage
situation exits and the battery needs to be
fully charged.
7. If the RED light flashes quickly for three (3)
seconds, a high amp situation exits and jack
will turn off after three (3) seconds. The jack
will reset itself in five (5) seconds and can be
used again until a high amp situation occurs.
A. The high amp draw situation can be
caused by too much load. Reduce the
tongue weight of the trailer.
B. The high amp draw can also be caused by
worn parts and the jack needs to be
serviced and owner should call Ultra‐Fab
for service options.
Page 2 of 6
ULTRA –FAB PRODUCTS, INC. 57985 SR 19, S. ELKHART, IN 46517 (800) 860‐7571 www.ultra‐fab.com
PHOENIX 5500 ELECTRIC TONGUE JACK
AUTO‐EXTEND
The Phoenix 5500 Electric Tongue Jack has two
new features; Auto‐Extend and Auto‐Retract.
AUTO‐EXTEND: Allows user to extend the jack
leg to the ground without having to continually
press and hold the Extend button. This is
especially helpful when detaching RV from tow
vehicle.
1. Initiate Auto‐Extend by pressing the Extend
Button quickly two times. The jack will
extend to the ground and stop.
2. For whatever reason, the Auto‐Extend can be
cancelled by pressing any other button.
AUTO‐RETRACT: Allows user to retract jack leg
without having to press and hold the Retract
button. This is especially helpful when user
wants to attach RV to tow vehicle.
1. Initiate Auto‐Retract by pressing the Retract
Button quickly two times. The jack will
retract to the top limit and stop.
2. For whatever reason, the Auto‐Retract can be
cancelled by pressing any other button.
MANUAL OPERATION
1. Disconnect the fuse. (unscrew and pull apart)
2. Remove twist plug in the access hole. (located
top center of the housing cover)
3. Insert the supplied
hole, over the drive hex head. Using your own
socket handle, rotate the socket clockwise to
retract and counter clockwise to extend.
4. When complete, remove socket and replace
twist plug, and reassemble the fuse
connection.
IMPORTANT: Recalibration must be performed
before resuming normal operation. Or damage
could result.
P/N 38‐944055
AUTO‐RETRACT
&
" socket in the access
9
/
16
rev 031317
Advertisement
