Advertisement
ASSEMBLY
1. With spring loaded lid closed, place Tub unit upside down on a non-scratching surface
(cardboard, carpet etc.).
2. Attach each of the 4 legs with 4 sets each of 6mm screws, lockwashers and nuts to the
brackets on the Tub unit (Fig 1).
3. Attach Storage Tray to holes located mid-way of 4 legs with 2 sets each of
6mm screws, lockwashers and nuts (Fig 2).
4. Thread the fi tting of the Flexible Metal "Gooseneck" fl uid outlet tube onto the Pump outlet
(Fig 3).
5. Place the Pump Box Lid over the open Pump Box with fl uid intake perforations and raised
ribs downward and over pump. Snap into place (Fig 3).
6. Place white fi brous 4" x 4" Filter Media pad into the perforated Filter Media Cover and
slide into place under raised-ribs of the Pump Box Lid (Fig 3).
7. Return the Tub unit to the upright position on its legs and open the spring-
tensioned lid.
8. Route the power cord of the Pump Box Assembly through the rectangular opening on the
side of the Tub Unit with the Inlet Filter downward and facing inward.
The Power Switch is visible through the rectangular opening. Hook the raised offset tab
on the rear of the Pump Box Assembly over the bottom edge of the rectangular opening
(Figs 4-5).
9. Check to see that the Tub drain plug is tightly installed.
10. Place the Parts Cleaning Tray over the ledges on the walls of the tub (Fig 3).
11. Make sure the Nozzle of the Flexible Metal "Gooseneck" Fluid Outlet Tube is
facing in toward the center of the Tub and downward (Fig 3).
12. The installation of the included Flow-through Parts Cleaning Brush and hose extension is
optional. The molded fi tting on the hose end opposite the brush
may be slipped into place over the Fluid Outlet Tube Nozzle (Fig 3).
13. Be sure the Nozzle or Brush outlet is facing in toward the center of the Tub
and downward.
14. Fill unit with suitable, water-based degreasing solution suffi ciently to cover the entire Inlet
Filter (approx. 12 gallons). Important Note: Follow degreasing solution mixing, usage and
safety label instructions carefully before using.
15. Plug power cord into an approved, grounded and GFI equipped 120 Volt AC,
60hz. Outlet.
16. Turn Power Switch to the "On" position. The Parts Washer is now ready for use.
To order parts and supplies: 800.345.1178 >> eastwood.com
Fig. 1
Fig. 1
Fig. 2
Fig. 2
Fig. 3
Fig. 3
Fig. 4
Fig. 4
Fig. 6
Fig. 6
Fig. 5
Fig. 5
3
Advertisement
