Advertisement
3.
OPERATION
3.1
ZERO SETTING
Prior to operation, perform a zero setting. To do this place the gauge foot on the zero set bar (fig 1 item 10) and press the
probe down until it is level with the base then press the 'ZERO' button, the gauge has been set to zero when the LCD
displays '0.00'. Note: After zero setting, the gauge retains this setting until the 'ZERO button is pressed again or battery is
removed.
3.2
PRODUCT USAGE
Switch on the gauge by pressing the ON/OFF button. Place the gauge foot across the tyre tread with the probe tip over the
tyre groove. Press the probe down until it stops moving then read the display. The pressure exerted by the tip of the
measuring probe must be uniform and constant to ensure correct and stable readings. Do not press too hard or incorrect
results will be recorded.
4.
MAINTENANCE
4.1
BATTERY INSTALLATION/REPLACEMENT
NOTE! The battery should last for one year of continuous use. If the display is blank or the digits are
flashing the battery voltage is too low, replace the battery with a new CR2032 power cell. If the
digits do not change when buttons are pressed or probe is moved, remove the battery for 1
minute to reset the unit. The battery should be removed if the gauge is not to be used for a long
period of time.
4.1.1
Remove battery cover (fig.2-A) by sliding backwards and lifting off.
4.1.2
Remove rubber spacer (fig.2-B) and exhausted battery (fig.2-C) and fit replacement with +ve side
uppermost. Place the rubber spacer on top of the battery and press it into the recess. Slide the
cover back into place.
4.1.3
Dispose of old battery in a safe and approved manner. Do not burn. If the display fails to alter
when the slide is moved, remove the battery, wait at least 1minute and then refit the battery.
4.2
CALIBRATION
Tyre Depth Gauge should be re-calibrated annually by Sealey Power Products.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be
sorted, taken to a recycle centre and disposed of in a manner which is compatible with the environment.
When the product is no longer required, it must be disposed of in an environmentally protective way.
Do not incinerate battery as it may explode when exposed to fire.
Do not attempt to open battery.
Contact your local solid waste authority for recycling information.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and
component parts without prior notice. IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim. INFORMATION: For a copy
of our catalogue and latest promotions call us on 01284 757525 and leave your full name, address and postcode.
VS0563
Environmental Protection.
Sole UK Distributor
Sealey Group,
Bury St. Edmunds, Suffolk.
01284 757500
01284 703534
email
fig.2
www.sealey.co.uk
Web
sales@sealey.co.uk
VS0563
ISSUE No:2 20/01/09
Advertisement
