Bosch MUM56320CH Instruction Manual page 24

en Operation
Warning!
The grating disc is not suitable for grating
soft cheese and cheese slices.
Working with the
continuous-feed shredder
Fig. G:
■ Press the Release button and
move the swivel arm to position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set
it down. Turn anti­clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to position 3.
■ Remove drive cover from the
drive of the continuous­feed shredder
(Fig. G-5a).
■ Hold disc holder at the lower end, ensuring
that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. G-6a).
In the case of reversible discs, ensure that
the required side is face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. G-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous­feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. G-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous­feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove cover
from the continuous­feed shredder and
empty feed tube.
24
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous­feed shredder in an
anti­clockwise direction and remove.
■ Rotate the lid in an anti­clockwise direction
and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. H).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem­
bled blender only and with the lid attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a
max. 0,5 litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep­frozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Fig. J:
■ Press the release button and
move the swivel arm to position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle on
mark on the base unit) and turn all the way
in an anti­clockwise direction.
■ Add ingredients.
Maximum amount of liquid = 1.25 litres;
maximum amount of frothing or hot liquids
= 0.5 litres;
Optimal processing capacity –
solids = 50­100 g;
■ Attach the cover and turn anti­clockwise all
the way into the blender handle. The cover
must be locked in position.
■ Set the rotary switch to the desired setting.