Table of Contents
Advertisement
One of the pyro channels isn't working
After a long time in pad-idle, the OnTime(sec) column of
data starts counting from 0 again
Something in the SD card data looks odd or out of
place. Examples might be columns filled with zeros,
large spikes in certain columns, far-from-nominal
battery voltage, etc.
User Requirements
The following constitute the guidelines that you agree to follow when using the Signal R2 kit. I f
you do not follow these, you void any guarantees or warranties for Signal R2, and neither
Joe Barnard nor BPS.space have any liability.
● I will use and fly Signal R2 only during high visibility conditions
● I will not use or fly Signal R2 under the influence of drugs or alcohol
● I will alert all persons in the general vicinity of the rocket before I launch
● I will ensure an audible countdown to ignition is conducted from at least 5 seconds
● I will never use or launch Signal R2 in the direction of people, property, or anything other
than open space
● I will never launch Signal R2 with the intent to harm
● I will only launch Signal R2 in accordance with FAR 101 by the FAA, the NAR's MRSC,
and the Tripoli Safety Code.
Copyright © 2019 Barnard Propulsion Systems, LLC
●
Use a voltmeter to check if power is sent to the
channel while ground testing the channel using
the Signal app
●
If the problem persists, please contact BPS
●
This is a known bug, and will not affect any of
the other readings or functions of the flight
computer. After about an hour of idling on the
launch pad, the computer has to reset the
pad-idle time variable.
●
Try removing the CONFIG.TXT file and
rebooting the computer. Poor formatting can
cause odd errors in the data.
●
Contact BPS with the flight or test data you're
seeing
Version 1.8, Jan 1, 2019
w ww.bps.space
Advertisement
Table of Contents
