Related Manuals for DanPumps S-WP Series
Summary of Contents for DanPumps S-WP Series
- Page 1 End-of-life, the pump must be recycled in accordance with local regulations. Version: 1.0 2015. English.
-
Page 2: Table Of Contents
If there are local restrictions concerning fire risks, they must be obeyed at all time. The pumps meet EU’s machine directive, see declaration of conformity at the back of this manual. DanPumps A/S guarantees that the pumps’ airborne noise level does not exceed the noise level between 70 to 74 dB (at normal operation). -
Page 3: Technical Specification
4. Technical specification. The S-WP pumps have a built-in motor in 3-phased version for either 50 Hz (230/400 V or 400/690 V) or 60 Hz (220 V, 460 V or 575/1000 V). Please see motor label for accurate information for this pump. Ambient temperature and media up to max. - Page 4 Other pumps have only one cable for both power and control. For installation of a longer cable please contact your local DanPumps A/S dealer, who can advise you about volt drop and dimensions. Also note that cable type and number of cables can vary depending on voltage, start method and country restrictions.
- Page 5 Pump curves – 50 Hz. Pump curves – 60 Hz.
-
Page 6: Handling The Pump
The pump will then automatically connect at bottom position on the DCB, loosen again when lifted. (Cooling jacket is an option) Always check the discharge pipe dimension is correct according to the required m³/h capacity. Contact your local DanPumps A/S dealer, who can advise you. -
Page 7: Electrical Installation
Check that the pipe dimensions are correct according to the required m³/h capacity. Contact your local DanPumps A/S dealer, who can advise you. Portable installation. When mounting this installation type, it is very important that the cables are installed in such a way that they do not bend, get damaged by vehicles etc. -
Page 8: Operation
This sensor must be connected to a relay in the extern control board. If moisture is registered in oil or stator housing, will the moisture relay cut off. Your local DanPumps A/S dealer can supply you with the correct relay as an accessory. 8. Operation. - Page 9 Type D - Dry Pit Installation. Installed in a dry well. The pump has a factory mounted adjustable stand. The height of the stand makes it possible to install a standard suction elbow. The pump volute is predrilled for standard DN flange. Type P - Portable Pit or fixed installation.
- Page 10 Check the stator unit. If the motor protection trips repeatedly, the stator must be inspected. Open the terminal housing cover. Disconnect the stator wires (spring terminals). Check the insulation resistance with min. 500V insulation tester. Test between U1, V1 and W1 and to GND. Test between U1, V1 and W1.
- Page 11 Mounting the impeller. Turn the shaft so that the keyway is upward. Put the key in its groove and push the impeller onto the shaft. Lock the impeller from rotating with a pipe or similar and fasten the impeller washer and screw. Mounting the stator.
-
Page 12: Pump Data - 50Hz
10. Pump data – 50Hz & 60Hz. -
Page 18: Pump Cutaway
12. Pump cutaway. -
Page 19: Ce Declaration
13. CE Declaration. - Page 20 - other reasons beyond DanPumps' control As a general rule, DanPumps will not accept to pay transportation/replacement/installation costs for faulty products. Warranty claims may be submitted by contacting the local DanPumps sales company or the point of sale. Benefit: Knowledge that DanPumps backs its products with clearly defined warranty terms •...
Need help?
Do you have a question about the S-WP Series and is the answer not in the manual?
Questions and answers