Parker EO2-FORM Assembly Instructions
Parker EO2-FORM Assembly Instructions

Parker EO2-FORM Assembly Instructions

Advertisement

EO2-FORM assembly instructions
D
1
L
L
1
● Take extra length into account
(see tube preparation chart)
5
● Remove internal and
external burrs
● max. chamfer 0.3mm x 45°
● Clean tube thoroughly
Material
combinations
● Select suitable materials
● See catalogue for exact tube
specifications

Tube preparation

● Cut and deburr thoroughly
● Cut and bend tubes exactly
S
D
2
L
2
● Minimum lengths L
2
of straight tubes (see chart)
6
● Chips, dirt, internal or external
burrs and paint prevent correct
tube insertion
Dirty tubes result in worn-out or
damaged tools

Material selection chart

Tube material
Fitting and nut
Steel
Stainless
Steel
Stainless
Steel
L
3
3
D
● Minimum lengths L
of straight
3
tube-ends before bend
(see chart)
E21
Sealing
material
material
Steel
Steel/NBR
or
Steel/FKM
Stainless
Stainless Steel/
Steel
FKM/NBR
Steel
Steel/NBR
or
Steel/FKM
4
● Cut tube squarely
● max ± 1° deviation
Do not use pipe cutters
● EO tube-cutting tool (AV)
for manual cutting
Catalogue 4100-5/UK
E

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EO2-FORM and is the answer not in the manual?

Questions and answers

Summary of Contents for Parker EO2-FORM

  • Page 1 Tube assembly EO2-FORM assembly instructions Material selection chart Material Tube material Fitting and nut Sealing combinations material material ● Select suitable materials Steel Steel Steel/NBR ● See catalogue for exact tube specifications Steel/FKM Stainless Stainless Stainless Steel/ Steel Steel FKM/NBR...
  • Page 2 Tube assembly EO2-FORM assembly instructions Tube preparation chart - Series L ● Minimum tube length ● Extra length ● Minimum straight length before bend Tube-OD Series Wall Steel Stainless Steel Stainless thickness Steel Steel 15.5 15.5 15.5 12.5 12.5 12.5 13.5...
  • Page 3 Tube assembly EO2-FORM assembly instructions Tube preparation chart - Series S ● Extra length ● Minimum tube length ● Minimum straight length before bend Tube-OD Series Wall Steel Stainless Steel Stainless thickness Steel Steel 15.5 15.5 12.5 15.5 12.5 12.5 12.5...
  • Page 4 Tube assembly EO2-FORM assembly instructions Tube forming with EO2-FORM F2 Reliable forming method ● Select suitable forming die ● Select suitable clamping dies ● Check clamping dies for dirt, Change tool only when drive switched off (button 0) according to tube material, outer...
  • Page 5 Tube assembly EO2-FORM assembly instructions Assembly check Tube OD check ● Check assembly result Tube Ø- min Ø max Ø Incorrect assemblies Series [mm] [mm] must be scrapped 6-L/S 10.2 8-L/S 12.2 10-L 13.2 14.2 12-L 15.2 16.2 15-L 18.5 20.2...

Table of Contents