Advertisement
Electrical Connections
Single Tetra Stick Installation
Power Supply
1
Connect the red wire (+) of the Tetra Stick to the red wire (+) of the power supply. Connect the black wire (-) of the Tetra Stick
to the black or blue wire (-) of the power supply. Seal all connections that could be exposed to water with electrical grade
RTV silicone
Mutiple Tetra Stick Installation
1
Add up total number of Tetra Sticks to determine the
appropriate number of 24VDC Class 2 Tetra LED drivers
to use based on the Specifications Charts for Tetra
Stick chosen (see pages 4-5).
AC line
3
Connect Tetra Stick using twist-on wire connectors or in-line (IDC) connectors. Join black wires together and red wires
together. Seal all connections that could be exposed to water with electrical grade RTV silicone.
NOTE: Make sure not to exceed LED driver power limits (see Step 1). Drawing above is for reference only; your lighting
layout may differ.
NOTE: All drivers except GEPS24-180U and GEPS24-300U must be enclosed or provided with a GEPSJB60 LED driver
extended enclosure.
NOTE: Refer to Power Supply Installation Guide for AC driver installation.
+
+
GEPS24-180
Red (+)
Red (+)
Power supply
Red (+)
Red (+)
Power supply
2
Connect the red wire (+) of the Tetra Stick to the red
wire (+) of the power supply. Connect the black wire (-)
of the Tetra Stick to the black or blue wire (-) of the
power supply.
3
Black or blue (-)
Black (-)
To Tetra Sticks
Black or blue (-)
Black (-)
To Tetra Sticks
Advertisement
