Subscribe to Our Youtube Channel
Related Manuals for PowerTek 727
Summary of Contents for PowerTek 727
- Page 1 Model 727/731 POWERTEK Model 727/731 Hydraulic Feed Chipper Operation & Maintenance Manual PowerTek Inc. P.O. Box 3 Lebanon, IN 46052 1-877-769-7835 5-09-12...
-
Page 2: General Operating Rules
GENERAL OPERATING RULES POWERTEK PREPARATION RULE 1. Always inspect the chipper before and after each 14. Inspect that all hydraulic hoses are in good working use to ensure safety and optimum performance. order and are not cracked, worn, or leaking. - Page 3 SAFETY POWERTEK SAFETY RULES DO’S DO NOT’S DO make sure that anyone who operates this chipper DO NOT operate the chipper alone. DO NOT allow reads and understands all operating instructions as to its children to operate the chipper. proper use and operation as well as all safety instructions.
- Page 4 WORK ZONE POWERTEK ! ! WARNING ! ! When operating this unit do not allow anyone to be in the danger zone while chipper is running or serious injury may occur.
-
Page 5: On Site Setup
ON SITE SETUP POWERTEK JACK STAND DISCHARGE CHUTE Once at your destination the chipper can be uncoupled Loosen the discharge chute clamp and rotate the chute from or left attached to the towing vehicle. In either to the desired position. Then tighten the chute clamp case, the weight should be transferred from the vehicle to lock it into place. -
Page 6: Operation
OPERATION POWERTEK To clear the discharge chute: Remove the chute clamp, STARTING GAS ENGINE take the chute off, and clear out any debris. Set the throttle to idle speed. If the engine is cold set the choke, then turn the key to “START” position. If the... - Page 7 OPERATION POWERTEK STARTING HYDRAULIC FEED When chipping always run the engine at full throttle. Auto feed will not work at a lower RPM. When the control bar is in the upright position it is in neutral and the feed rollers should not be turning.
Need help?
Do you have a question about the 727 and is the answer not in the manual?
Questions and answers