Operation; Setting The Time - Silvercrest SSRM 20 A1 Operating Instructions Manual

Operation

Setting the time

NOTE
► You can only set the time when no alarm is active .
► If you do not press any buttons for approximately
5 seconds, the device exits the settings mode .
All changed settings are saved .
► You can also hold the "‒"
quickly through the numbers .
► If you select the 12-hour format in the basic settings,
the abbreviation PM is displayed in front of the time
between noon and midnight . The abbreviation AM is
displayed between midnight and noon .
♦ When the device is switched off, press the MODE/
ton . The display
( or
♦ Press the "‒"
format .
♦ Press the MODE /
The hours flash on the display
♦ Press "‒"
♦ Press the MODE /
The minutes flash on the display
♦ Press "‒"
♦ Press the MODE /
The display
■ 12 │ GB │ IE │ NI
will show the current time format
) in flashing digits .
or "+"
button
or "+" to set the required value .
button
or "+" to set the required value .
button
now shows the set time .
or "+"
button, to set your preferred
to save your settings .
.
to save your settings .
.
to save your settings .
button to scroll
SSRM 20 A1
but-