Bearing Removal - PEERLESS TU Series Repair Instructions

USING A BEARING PULLER
-COURTESY OF NEW DEPARTURE-
USING AN ARBOR PRESS
1.
2.
1.
2.
3.
BEARING MOUNTING
1. PLACE BEARING PULLER
BEHIND BEARING INNER
RING. SET PULLER JAWS
SO THAT THEY WILL NOT
SLIP OVER THE INNER RING
AND DAMAGE SPARATOR
OR SHIELD WHEN PRESSURE
IS APPLIED.
2. FORCE BEARING OFF SHAFT
BY A STRAIGHT PULL.
DO NOT COCK BEARINGS.
USING AN ARBOR PRESS
1. REST THE BEARING INNER
RING OR BOTH RINGS
(NEVER THE OUTER RING
ONLY) AGAINST A PAIR OF
FLAT BLOCKS.
2. FORCE THE SHAFT OUT BY
A STEADY PRESSURE – KEEP
SHAFT STRAIGHT – DO NOT
ALLOW SHAFT TO COCK OR
DROP.

BEARING REMOVAL

FIGURE 2, BEARING REMOVAL AND MOUNTING
PLACE THE BEARING ON
TWO FLAT BLOCKS SO
THAT THEY CONTACT THE
INNER RING OR BOTH
RINGS OF THE BEARING.
HOLD SHAFT STRAIGHT –
FORCE THE SHAFT BY A
STEADY PRESSURE, UNTIL
THE BEARING IS SEATED
AGAINST THE SHAFT
SHOULDER.
USING TUBING
PLACE THE BEARING ON
SHAFT.
PLACE TUBING OVER SHAFT
IN CONTACT WITH THE
INNER RING OF THE
BEARING.
APPLY HAMMER ALTERNATELY
AT OPPOSITE POINTS –
AVOID COCKING.
7
2883820