Section 6: Unpacking; Section 7: Set-Up Instructions; Tools Required - Yard Machines 580 Series Operator's Manual

SECTION 6: UNPACKING

Removing Unit from Carton
• Remove staples, break glue on top flaps, or cut tape at carton end and peel along top flap to open carton.
Remove loose parts if included with unit (i.e., operator's manual, etc.). See Figure 3.
• Cut along dotted lines and lay carton down flat. Remove packing material. Roll or slide unit out of carton.
Check carton thoroughly for loose parts.
NOTE: Make sure not to crimp the cables while removing the loose parts or the entire unit from the carton.

SECTION 7: SET-UP INSTRUCTIONS

NOTE: This operator's manual caters to several models of lawn mowers. Please follow instructions pertaining
to your unit only.
Reference to right or left hand side of the mower is observed from the operating position.

Tools Required

Pair of Pliers
Set of adjustable wrenches
Funnel
Important: This unit is shipped WITHOUT GASOLINE or OIL in the engine. Be certain to service engine with
gasoline and oil before operating your mower.
Disconnecting Spark Plug
• Before setting up your lawn mower, disconnect the spark plug wire from the spark plug, and ground it
against the engine. See Figure 4.
• If the engine is equipped with the optional rubber boot, attach the boot to a bolt on the engine to ground.
Figure 3
Rubber
Spark Plug
Boot
Wire
Figure 4
Spark
Plug
8