Nevir NVR-128D User Manual page 9

Radio
1. Press ON / STAND BY to switch on the radio.
2. Press BAND once or more to select FM or AM waveband.
3. The display shows the radio station details throughout the radio mode.
4. Select your station by using TUNING + or TUNING –
5. Adjust the sound with VOLUME.
6. To switch off the radio, press ON / STAND By once.
Tuning
Manual tuning
Press TUNING + or TUNING – briefly, once or more until the right frequency is
found.
Automatic tuning
1. Press and hold down TUNING + or TUNING – until the display frequency starts
to run.
2. When a station of sufficient strength has been found tuning stops, or you can
stop automatic tuning by pressing TUNING + or TUNING – again.
Presets
You can store the frequencies of up to 50 radio stations in the memory, (30 in FM
wave bands; 20 on AM wave band). A stored frequency can be erased from the
memory by storing another frequency in its place.
1. Press PROGRAM once to enter programming mode.
2. Select your wave band and tune to your desired station (See TUNING).
3. Press PROGRAM once again to confirm the selected station.
4. Press PRESET + or PRESET – to select the desired memory location.
5 To listen to a preset station:
• select your waveband;
• press the PRESET + or PRESET – for selecting your desired station.
To improve reception:
- For FM, pull out the telescopic aerial. To improve FM Reception incline and turn
the aerial, reduce its length if the FM-signal is too strong (very close to a
transmitter).
- For AM, the set is provided with a built-in aerial, so there is no need to use the
telescopic aerial. Turn the set to find the best position.
Volume
Adjust the sound with the controls VOLUME + or VOLUME -
You may connect headphones with 3.5mm, plug to socket PHONES. The
loudspeaker is then muted.
-Page 3